Flake and Chip Epoxy Floors in Berkley, MI

Flake and chip epoxy floors in Berkley MI are a practical choice for commercial spaces that take real wear: retail back-of-house, auto shops, salons, clinics, warehouses, and restrooms. The system is a broadcast — vinyl flake chips are cast by hand into wet resin, left to cure, then scraped and sealed. What you get is a hard-wearing, speckled floor with texture underfoot that hides dirt, dust, and scuffs far better than a smooth single coat.

This page covers how the system works, what it costs, and what to expect during installation. For a broader look at the chemistry and system options, see our full guide to flake epoxy flooring.

How the Flake Broadcast System Works

A flake floor is built in layers:

  1. Concrete prep. The slab is ground or shot-blasted to open the surface, and cracks or pits are repaired. Prep quality decides how well the floor bonds — there is no shortcut here.
  2. Base coat. A pigmented epoxy or polyaspartic base is rolled out.
  3. Flake broadcast. While the base is wet, vinyl chips are broadcast across the entire floor until rejection — the surface can't hold any more. Full broadcast means dense, even coverage.
  4. Scrape and seal. Once cured, protruding flakes are scraped flat, the floor is vacuumed, and one or two clear topcoats seal everything in.

The result is a seamless surface with genuine texture. That texture is the main reason flake floors read as less slippery than a smooth epoxy coat — the chips break up the film and give shoes something to grip, even when the floor is wet. If slip resistance matters for your space, say so during the estimate; topcoat selection can be adjusted accordingly.

Why Commercial Clients Choose Flake

One important note on blend selection: blends are chosen from physical samples, not from a screen. Colors on a monitor look different from the actual chips under your lighting. We bring samples to the site so you can see the blend on your own concrete and under your own lights before committing.

Cost Drivers and Typical Ranges

We don't publish firm prices because no two slabs are the same. Flake and chip epoxy floors are typically priced per square foot, and the number moves with a few factors:

As a general frame, commercial flake installations in Metro Detroit commonly fall somewhere in the mid-single-digit to low-double-digit dollars per square foot range. You'll get an exact figure after a site visit — no surprises, no change-order games.

Installation Timeline

Most commercial flake projects in Berkley run one to three days depending on square footage and the number of topcoats. The floor is typically back in service within 24–72 hours after the final seal, depending on the topcoat chemistry and ambient conditions. If your business can't close, we'll work in phases or overnight windows.

Why Work With Us

We install flake and chip epoxy floors across Oakland County, including Berkley, and we stand behind the work with a written warranty on workmanship on every installed floor. No vague verbal assurances — the terms are in writing.

Get a Quote

Ready to see blend samples on your slab? Use the quote form on our website. Share your square footage, location, and a few photos if you have them, and we'll follow up with scheduling for a site assessment and a written estimate — no phone tag required.