Epoxy Floor Repair and Recoat for Commercial Kitchens, Breweries and Food Production

Food and beverage facilities are hard on floors. Hot washdowns, constant forklift traffic, organic acids from fermentation and food waste, thermal shock from steam cleaning and freezer doors — a floor that looked fine at install can be peeling, delaminating or pitted within a couple of years. This page covers how epoxy floor repair and recoat for commercial kitchens, breweries and food production actually works: what we look at, what we repair, and when a recoat is the wrong answer.

Why These Floors Fail the Way They Do

Most failures we see in commercial kitchens, breweries and food production come down to one of a few causes:

What Repair and Recoat Involves

Every job starts with an assessment of the existing floor, not a guess. Depending on what we find, the work usually falls into one or more of these:

Localized repair. Cutting out and rebuilding delaminated or damaged patches with epoxy repair mortar, re-bonded to sound concrete. This is common around drains, dock edges and traffic lanes.

Re-profiling. Grinding and filling to restore slope to drains, smooth out trip hazards at joints, and level areas where the old coating has stepped or cratered. In food production, correct falls matter for drainage and hygiene compliance.

Mechanical prep of the sound areas. Diamond grinding or shot blasting of everything that will be recoated. This is the step that determines whether the new coating stays down. There is no shortcut that lasts.

Recoating. A new build of epoxy, or epoxy with a polyurethane or polyaspartic topcoat where chemical and thermal resistance is the priority. Line marking, coving repairs and drainage transitions are handled at this stage if needed.

When Recoating Is the Wrong Answer

Sometimes the honest answer is that a recoat would be money spent on a floor that's already finished. If the coating is widely delaminated, if moisture vapour is pushing it off, if the slab itself is contaminated or crumbling, then coating over it just delays the same failure by a year.

In that case the floor needs taking back to concrete — full mechanical removal, addressing the underlying cause (moisture barrier, slab repair, slope correction) and installing fresh. We tell you this at quoting stage, with the reasoning laid out. It costs more up front and it's the right call. You will not find out mid-job that the scope has changed.

Downtime, Scheduling and Food Safety

We know the floor is the last thing you can afford to shut down for. Work is planned around your production calendar — weekends, shutdown periods or staged sections so part of the facility keeps running. Recoated areas need to cure before they see washdown and traffic; we'll give you realistic return-to-service times per zone, not optimistic ones.

All materials used in commercial kitchens, breweries and food production areas are selected for food-contact-adjacent suitability, HACCP-friendly cleaning regimes and slip resistance appropriate to wet areas.

Cost Drivers

We don't publish fixed prices because two floors of the same square metres can differ enormously. What moves the number:

As a rough sense of scale: localized repairs and a recoat of sound areas sit at the lower end; full take-back-to-concrete and reinstallation sits at the top. You'll get a line-itemed quote so you can see what each part costs and why.

Warranty

Installed floors are covered by a written warranty on workmanship. The terms are stated in writing on your quote and job documentation — no fine print surprises.

Where This Fits

This page is one part of our work in food and beverage environments. For the broader picture — coatings, screeds and coving across the sector — see Food and Beverage Flooring.

Get a Straight Answer on Your Floor

If your floor is peeling, lifting or wearing out, the first step is an honest assessment: repair, recoat or rebuild. Use the quote form on this website to book an inspection. Tell us what the floor is doing and when, and we'll come back with a clear recommendation and a line-itemed price — including the times when recoating isn't the right answer.