Commercial and industrial epoxy flooring for auto shops and dealerships is a different job from a garage floor coating in someone's home. The floor in a working service bay or a dealership service drive sees lift traffic, rolling jacks, transmission jacks, forklifts and parts carts, hot tires, brake cleaner, motor oil, antifreeze, and daily washdowns. A thin decorative coating will not survive that. What works is a heavier-build resin system specified around what actually crosses the floor and what actually gets spilled on it.
If you are comparing options, start here: auto shops and dealerships have their own page covering the industry in more detail.
Commercial and industrial epoxy flooring in these facilities is typically a multi-coat, heavier-build system rather than a single rolled coat. The reasons are practical:
The right build thickness and topcoat hardness depend on the traffic. A quick-lube bay and a full-service repair shop are not the same floor. A dealership showroom and a dealership service drive are not the same floor either.
A good specification starts with two questions: what moves across the floor, and what lands on it?
Traffic type drives the build. Forklifts and vehicle lifts call for a thicker, more rigid system. Pedestrian-only areas like showrooms and customer walkways can use a lighter build focused on appearance and slip resistance. Mixed-use floors get zoned - heavier build in the bays, lighter finish up front.
Spill profile drives the resin chemistry. Oil and coolant exposure calls for chemical-resistant topcoats. Solvent-heavy shops need systems rated for solvents. Washdown areas need seamless or near-seamless transitions so water cannot get under the coating.
Finish drives safety. Aggregate broadcast or slip-additive finishes are standard in bay areas where floors get wet and oily. Showroom floors lean toward a smoother, glossier finish with slip resistance still meeting code.
There is no single off-the-shelf answer. A floor that works in a body shop with heavy solvent use may be overkill for a tire shop, and under-specified for a dealership service drive running lifts all day.
Most auto shops and dealerships cannot shut down for a week. Lifts have to lift, service appointments are booked, and revenue does not pause. That is why installation in these facilities is usually phased.
A typical phased approach:
Phasing adds coordination, but it is the difference between a floor project the business survives and one it doesn't.
Firm pricing requires a site walk, but the cost drivers are consistent:
Budget ranges only make sense after those factors are known, so treat any number quoted sight-unseen with skepticism.
Installed floors are backed by a written warranty on workmanship. The specifics of length and coverage are stated in that written warranty - ask for it in writing as part of any quote, and read it before signing.
The fastest way to a real number and a real floor plan is the quote form on this website. Describe your facility - bay count, traffic, spills, and scheduling constraints - and you will get back a specification and pricing built around your actual floor, not a generic package. For the broader industry overview, see auto shops and dealerships.
CTA: Request a quote through the form on this site. Include your square footage, a rough description of traffic and chemical exposure, and your scheduling limits. You will get a phased plan and a written scope you can hold someone to.