If you've booked an epoxy floor repair and recoat: what to expect on the day is straightforward, but it helps to know the sequence. A recoat day is not just rolling new material over the old floor. Most of the work happens before any epoxy comes out of a bucket, and the quality of that prep decides how long the new coating lasts. Here's the honest run-through.
A proper contractor looks at the floor first and tells you one of two things: a recoat is the right answer, or the floor needs to be taken back to concrete. That decision gets made before the work is scheduled, not partway through the day. If the existing coating is delaminating across large areas, was applied over contaminated concrete, or has failed badly enough that spot repairs won't hold, recoating is throwing good money at a bad base. That conversation belongs at the quote stage.
If a recoat is confirmed, you'll get clarity on what the prep involves, how long the floor will be out of service, and what affects the cost — square footage, condition of the existing coating, number and size of repairs, and how much joint or crack work is needed.
Site protection and access. The crew sets up dust control, plans material staging, and confirms with you which areas are being done and when you can walk or drive on them. Keep the area clear of stock, vehicles, and equipment beforehand — it saves everyone time.
Cleaning and degreasing. Oil, forklift residue, and general grime have to come off. Coating over contamination is the fastest way to get peeling, so this step is never skipped.
Mechanical prep. The existing floor gets abraded or diamond-ground so the new coat can bond. You'll hear grinders running for a good chunk of the day. This creates dust; proper contractors contain it with HEPA-equipped equipment, but expect some noise and movement.
Repairs. Cracks, spalls, and damaged joints get filled and patched. Repair material needs time to set before coating over it, which is one reason a small repair job can still be a full-day project.
Primer and recoat. Once prep passes inspection, primer goes down, then the new coat. Application is usually the quickest part of the day — an hour or two of actual coating for a typical warehouse bay.
Cure and handover. Light foot traffic is typically possible within 24 hours, with longer wait times before forklifts or heavy loads — your contractor will give you specific times for the product used. Getting the timeline in writing before the day starts is fair and reasonable.
We won't quote numbers blind. What drives price: total area, how much mechanical prep the old coating needs, how many repairs, whether joints need work, and what coating system suits your traffic. A small clean floor with a few patch repairs sits at one end; a large floor with widespread cracking sits at the other. A site visit and a written quote is how you get a real number — use the quote form on our website.
Can we stay open during the work? Sometimes, if the floor can be done in sections. Sectional work adds days but keeps operations running.
How long will the recoat last? Done over sound prep, a recoat generally buys years of service life, not months. Exact lifespan depends on traffic and use, and anyone promising a precise figure without seeing your floor is guessing.
What if the prep uncovers worse problems? Small surprises get handled within the original scope. If prep reveals the floor genuinely needs full strip-back to concrete, that stops work — you get a call, not a surprise invoice.
Repeat: a recoat is only worth doing over a sound base. For a deeper look at repair-versus-recoat decisions and full remediation, see our epoxy repair guide: epoxy repair.
Work we install is covered by a written warranty on workmanship. It's on paper, and it's honoured — if something goes wrong with the install, we come back and fix it. Ask to see the warranty terms before you commit.
Ready to find out whether your floor needs a recoat or a rebuild?
Submit the quote form on our website with a few details and photos of the floor. You'll get an honest assessment — including if a recoat is the wrong answer — and a written scope before any work is scheduled.