Flake and Chip Epoxy Floors in Washtenaw County

Flake and chip epoxy floors in Washtenaw County are a practical choice when you want a floor that holds up to real use without looking like a slab of gray paint. The system is a broadcast: we roll resin onto the prepared concrete, cast vinyl flake into it while it's wet, let it cure, scrape the excess flat, and seal it with a clear topcoat. The result is a dense, speckled surface that's hard-wearing, easy to clean, and textured enough to feel sure-footed underfoot.

That texture is the point. A smooth epoxy coat can read as slick, especially in a garage or workshop where water, oil, or dust show up. Flake interrupts that surface. The chips sit in the resin and break up the plane of the floor, so the finished surface grips better than a smooth coat. That's why flake and chip epoxy floors are common in garages, basements, light commercial spaces, and anywhere people walk in off Michigan pavement with wet boots.

Another practical benefit: the speckle hides dirt. A flake floor doesn't show every crumb, scuff, or hair the way a solid color does, which means it looks clean longer between sweeps. For shops and service bays in Washtenaw County, that's less time fussing over appearances.

How the blend gets chosen

The flake blend is the look of the floor, and we don't ask you to pick it off a phone screen. Colors on a monitor shift with backlight and calibration, and a blend that looks gray on your laptop can read blue or brown on the floor. We bring physical samples so you can see the actual chips, actual blends, under the actual light of your space. You hold the sample against your walls, your cabinets, your lighting, and choose from there. Blends run from subtle grays and tans that hide everything to higher-contrast mixes with black, white, or color accents. Some people want the floor to disappear; some want it to be a feature. Both are fine — but the decision gets made from samples in hand, not from a picture.

What goes into a flake floor

Every installation starts the same way: the concrete gets ground or shot-blasted to open the surface, cracks and pits get repaired, and only then does resin go down. Preparation is most of the work, and it's the part that decides whether the floor stays down for years or starts peeling at the garage door. After the base coat, the flake gets broadcast to rejection — as much as the wet resin will hold. Once cured, we scrape and sometimes sand to knock down the loose flake, then apply the clear topcoat or topcoats that lock everything in.

What drives the cost

We don't quote firm prices sight-unseen, and you should be wary of anyone who does. Cost depends on square footage, how much concrete repair the slab needs, the number of topcoats you choose, and how much prep the existing floor requires. A clean, sound two-car garage sits at one end of the range; a cracked, oil-stained shop floor at the other. After we look at your space, you get a written scope and a firm number. Installed floors carry our written warranty on workmanship, so what's promised on paper is what gets honored.

Serving all of Washtenaw County

We install flake and chip epoxy floors across Washtenaw County — Ann Arbor, Ypsilanti, Saline, Dexter, Chelsea, Milan, and the townships in between. Residential garages and basements make up a lot of the work, along with small commercial floors where appearance and durability both matter. For the full picture of our coverage area, see Washtenaw County epoxy services.

Ready to talk about your floor?

Send us a few details through the quote form on this website — square footage, roughly where the floor is, and what it's used for now. We'll come look at the slab, walk you through flake samples, and give you a written quote with no guesswork in it.