Flake and chip epoxy floors in Oakland County are one of the most practical finishes you can put over concrete. The system is straightforward: a base coat of resin goes down, vinyl flake is broadcast into it by hand until the surface is fully saturated, the excess is scraped back, and everything is sealed under clear topcoats. What you end up with is a hard-wearing, speckled floor that hides dirt, resists hot-tire pickup, and gives real grip underfoot.
The flake is not just decoration. Because thousands of flakes sit proud of the resin layer, the finished surface has a fine texture to it. That texture is why a flake floor reads as less slippery than a smooth rolled coat, especially when it gets wet. In a garage, a mudroom, a shop, or a light commercial space, that difference matters on a Michigan winter day when people are tracking in snow and salt.
The speckled pattern also does quiet work every day. Dirt, dust, sawdust, pet hair, and small scuffs disappear into the blend. A flake floor looks clean far longer between sweepings than a solid-color coat, which shows every mark.
Across Oakland County, we install flake and chip epoxy floors most often in:
The same system scales. A residential garage and a commercial back-of-house use the same materials, just scaled to the square footage and the traffic the floor will see.
Every flake blend is a mix of two, three, or more colors, and the way those colors sit together changes the whole look of the floor. A grey-and-white blend reads clean and neutral. Blends with tan, black, or brown tones hide dirt even harder and suit busier spaces.
We do not ask you to pick a blend off a screen. Screen colors never match how flakes actually look once they are broadcast into resin and sealed under topcoats. Instead, you look at physical samples, in the space, under your own lighting. Blend choice is made from samples, not from a screen, because that is the only way to know what the floor will actually look like finished.
We do not quote firm prices on a web page, because honest numbers depend on the floor. The main cost drivers are:
As a general frame, flake systems sit above a single solid-color epoxy coat and below high-end decorative metallic finishes. Most residential garage projects land in a mid four-figure range; commercial work is quoted per job. You get a written, itemized estimate before anything starts.
Prep is most of the job. The concrete is ground to open the surface, cracks and pits are repaired, and only then does the base coat go down. Flake is broadcast to rejection, left to cure, scraped and sanded flat, then sealed. Most residential installs take two to three days depending on weather and cure times, and you keep vehicles off the floor for the first few days after sealing.
Every installed floor is backed by a written warranty on workmanship. It is on paper because we stand behind the installation, not just the materials.
If you are comparing flake and chip epoxy floors for a garage or commercial space in Oakland County, the fastest way to get real numbers is our quote form on this site. Tell us the space, the approximate square footage, and the condition of the concrete, and we will follow up with next steps and a site visit if the project calls for one.
Learn more about our full service area on the Oakland County epoxy flooring page.