Epoxy Floor Repair and Recoat in Oakland County

If you have an epoxy or resin floor in Oakland County that has worn through, peeled at the edges, lifted under hot tyres, or taken impact damage, an epoxy floor repair and recoat may be all it needs. Sometimes it isn't — and we will tell you that before the work starts, not in the middle of it.

What Can Actually Be Repaired or Recoated

Not every tired floor needs to be torn out. An existing resin floor is a good candidate for repair and recoat when:

In these cases we repair the damaged areas, grind and prepare the surface, and apply a fresh recoat. The result is a floor that performs like new at a fraction of the cost and downtime of a full strip and re-install.

When a Recoat Is the Wrong Answer

A recoat applied over a failing floor fails too — usually within months. If the existing coating has lost bond across large areas, is contaminated with oil or curing compounds that won't grind out, or was never properly prepared in the first place, the honest answer is to take the floor back to bare concrete and start over.

We assess this before quoting. If your floor needs stripping rather than recoating, you'll hear it upfront, with the reason why. You won't get a cheap recoat quote that turns into an argument later.

Our Process

  1. Assessment – We inspect adhesion, moisture, contamination, and the extent of damage across the whole slab, not just the visible problem spots.
  2. Repair and re-profiling – Delaminated spots are removed, cracks and holes filled with appropriate repair compounds, and the surface ground flat.
  3. Surface preparation – Mechanical grinding or shot blasting to give the new coating a proper mechanical bond. This step is where most coating failures begin, so we don't cut corners on it.
  4. Recoat – A fresh epoxy system matched to the service the floor actually sees — foot traffic, forklifts, hot tyres, or chemical exposure.

Throughout Oakland County we handle repair and recoat work in residential garages, workshops, light industrial units, and commercial spaces.

What Drives Cost

We don't publish fixed prices because floors vary too much, but the main cost drivers are straightforward:

As a rough frame: minor repairs with a recoat sit at the low end, while floors needing extensive stripping approach the cost of a new installation — which is exactly why we assess before quoting.

Warranty and Next Steps

Repairs and recoats we install are covered by a written warranty on workmanship. If something goes wrong because of how the floor was prepared or applied, the warranty means something — it's honoured, not just printed.

If you're in Oakland County and unsure whether your floor needs a repair, a recoat, or a full strip, tell us what you're seeing. Send a few photos and the approximate square footage through the quote form on our website, and we'll come back with an honest assessment and a clear scope.

Ready to find out what your floor actually needs? Use the quote form on this site to get started.