Metallic Epoxy Floors in Farmington Hills, MI

Metallic epoxy floors in Farmington Hills, MI are a decorative coating system built for commercial interiors that need to look better than bare concrete without becoming a maintenance headache. The system uses a two-part epoxy base with metallic pigments suspended in it. While the resin is still wet, the installer moves those pigments through the floor with squeegees, trowels, and sometimes a heat gun or torch. The result is a marbled, three-dimensional surface with real depth — it reads more like polished stone than a painted floor.

If you want the full technical breakdown of how these systems are built, layer by layer, see our guide to metallic epoxy floors.

Where Metallic Epoxy Makes Sense in Farmington Hills

Commercial property owners and facility managers around Farmington Hills, MI typically specify metallic epoxy for spaces where the floor is part of the first impression:

Because the coating is seamless and non-porous, there are no grout lines or joints collecting dirt, and routine maintenance is a dust mop and an occasional damp mop with a neutral cleaner. That matters in high-traffic commercial settings where daily cleaning budgets are fixed.

Every Pour Is One of a Kind — Said Up Front

This is the part we tell every client before work starts, not after: no two metallic epoxy floors are identical, and the pattern cannot be reproduced exactly from a photograph. If you show us a reference image, we can match the general character — color palette, movement, density of the figure — but the specific swirls and veins are a product of pigment, resin chemistry, temperature, and hand movement in real time. Treat a photo as a direction, not a promise of a copy.

Setting that expectation in writing before the pour prevents the single most common dispute in decorative flooring. If exact pattern repeatability is a hard requirement for your project, solid-color epoxy or quartz systems are the better fit, and we will say so.

How Installation Works

  1. Concrete prep. The slab is mechanically ground or shot-blasted to open the surface. Any cracks or joints are addressed based on condition.
  2. Primer and base coat. A tinted epoxy base establishes the background color.
  3. Metallic pour. The pigmented metallic epoxy is applied and worked while wet. This is where the pattern forms — and where timing matters, since the working window is limited.
  4. Topcoat. A clear polyurethane or polyaspartic topcoat seals the floor and provides abrasion and chemical resistance.

Most single-room commercial installs run two to four days depending on slab condition, square footage, and cure times between coats. Occupied spaces can often be phased to limit downtime.

What Drives Cost

We don't quote firm prices without seeing the slab, but the cost drivers are consistent:

As a broad range, metallic epoxy floors typically land well above a basic solid-color epoxy and well below natural stone or terrazzo. You'll get exact numbers after a walkthrough and written estimate.

Our Warranty

Installed floors are covered by a written warranty on workmanship. The terms are spelled out in the estimate and contract — no verbal assurances, nothing left to memory.

Local Considerations

Michigan's freeze-thaw cycles and de-icing salts matter for slab condition, especially near entries. For a broader look at our work in the area, see our Farmington Hills, MI service page.

Get a Quote

Ready to talk about metallic epoxy for your space? Submit the quote form on our website with your square footage, location, and a rough timeline. We'll follow up to schedule a slab inspection and provide a written estimate.

Explore more coating options and service areas on our site.