Flake and Chip Epoxy Floors in Royal Oak, MI

Flake and chip epoxy floors in Royal Oak MI are a practical choice for commercial properties that need a floor to hold up under real traffic. The system is sometimes called a broadcast system: vinyl flakes are cast — broadcast by hand — into a wet resin base, then knocked back and sealed under a topcoat. The result is a hard-wearing, speckled floor with a slightly textured surface that resists slipping and does a good job of hiding dirt, dust, and scuffs between cleanings.

This page covers how the system works, where it fits best, and what drives the cost. If you want the full technical breakdown first, see our flake epoxy guide.

How the broadcast system works

A flake floor is built in layers:

  1. Base coat — an epoxy primer and body coat rolled onto the prepared concrete.
  2. Broadcast — vinyl flakes are thrown into the wet resin until it can't accept any more. Full coverage here is what gives the floor its density.
  3. Back-trowel or scrape — once cured, the flake layer is knocked flat to remove loose and standing flakes.
  4. Seal coats — one or more clear topcoats lock everything in and set the final sheen, from matte to gloss.

The flakes themselves come in blended color mixes. Those blends are chosen from physical samples on site, not from a screen — colors on a monitor never match what cures on the floor, so we bring boards and you pick from the real thing.

Why texture matters

The flake layer adds texture to the surface, which is why a flake floor reads as less slippery than a smooth, single-pour epoxy coat. In commercial spaces — break rooms, locker areas, retail back-of-house, auto service bays, restrooms — that extra grip underfoot matters, especially where water or dust ends up on the floor. It's not a magic fix and it doesn't replace good housekeeping, but as far as seamless floors go, flake and chip systems are among the more sure-footed options.

The texture also hides dirt. A speckled, multi-tone blend camouflages hairline scuffs, dust, and daily wear far better than a solid color. That means the floor still looks presentable between scheduled cleanings — which is often the difference between a floor that "ages well" and one that looks tired in a year.

Where it fits in Royal Oak commercial spaces

Flake and chip epoxy floors suit a wide range of properties around Royal Oak MI:

Concrete condition matters. Cracks, moisture, and old coatings all need to be addressed before any resin goes down — see our Royal Oak service page for how we handle prep and what to expect during the job.

What drives the cost

We don't quote firm prices on a page, because the honest answer is that flake floors are priced per job. The main drivers:

A straightforward garage floor over sound concrete will land well under what a moisture-remediated warehouse slab needs. We'll tell you which one you're looking at before any commitment.

Warranty and next steps

Installed flake and chip floors come with a written warranty on workmanship. It's on paper, and we honour it — you're not relying on a verbal promise.

If you're considering flake and chip epoxy floors for a commercial space in Royal Oak, the next step is simple: fill out the quote form on our website. Tell us the square footage, the space type, and the condition of the existing concrete, and we'll follow up to look at the floor and put a real number on it.