Flake and Chip Epoxy Floors in Redford, MI

Flake and chip epoxy floors in Redford MI are a practical choice for commercial and light-industrial spaces that take daily abuse — shop floors, break rooms, restrooms, showrooms, garages, and back-of-house areas. The system is straightforward: a base coat of resin is applied, vinyl flake chips are broadcast into it by hand until the surface is fully loaded, the excess is scraped back, and the whole thing is sealed with a clear topcoat. What you're left with is a hard-wearing, slip-resistant floor with a speckled finish that hides dirt far better than a plain smooth coat.

If you're weighing options for a property in the area, our Redford, MI service page covers the full range of coatings we install locally, and our flake epoxy guide breaks down the system in more depth.

How the Broadcast System Works

The flake system is a multi-layer build, not a single pour:

  1. Surface prep. The concrete is ground to open the surface and remove old coatings, contamination, and weak laitance. This step determines adhesion more than anything else.
  2. Base coat. A tinted epoxy or polyaspartic base is applied while the surface is still open.
  3. Broadcast. Vinyl flakes are cast into the wet resin until it can't accept any more. Once cured, the excess is scraped and the surface is sanded smooth.
  4. Seal coats. One or more clear topcoats lock the flakes in and set the final sheen and texture.

The result is a floor that reads as one continuous surface but has real tooth underfoot.

Why the Texture Matters

This is the main reason property owners ask for flake and chip epoxy floors over a smooth solid-color coat: the flakes sit in the film and create texture, so the floor feels less slippery underfoot, especially when it's wet or dusty. That matters in restrooms, kitchens, entryways, and anywhere forklifts, carts, or foot traffic meet moisture.

The speckled pattern also does quiet, unglamorous work. Dirt, scuffs, tire marks, and small debris simply don't read against a flaked surface the way they do on a plain grey or white floor. For high-traffic commercial space, that means it looks clean longer between actual cleanings.

Choosing a Blend in Person, Not on a Screen

Flake blends are made from combinations of colored vinyl chips, and the same blend can look noticeably different depending on base coat color, flake density, and topcoat sheen. Photos and screen renders flatten all of that out.

That's why we treat blend selection as a physical process. You look at actual samples, in the space, under the lighting the floor will actually live with. We'll walk you through full-broadcast versus partial-broadcast looks, neutral blends versus bolder mixes, and what each option does to maintenance over time. No decisions get made from a phone screen.

What Affects Cost

We don't quote firm prices without seeing the slab, but the main drivers are consistent:

Most commercial flake projects land in a moderate range relative to other resinous systems — more than a single-coat sealer, less than thick-build mortar systems. The quote you get will itemize prep, materials, and coats so you can see where the money goes.

Workmanship Backed in Writing

Every installed floor comes with a written warranty on workmanship. It's not marketing copy — it's a document that spells out what we stand behind on the install, and we honor it. Combined with proper prep, a flake floor is a long-service-life surface, not a short-term patch.

Get a Quote

If you're considering flake and chip epoxy floors for a commercial property in Redford MI, start with the quote form on our website. Tell us the square footage, how the space is used, and roughly when you'd want the work done. We'll schedule a site visit, check the slab, and put a written estimate in front of you — samples in hand, no guesswork.