If you manage or own commercial property in Madison Heights, MI, and you need a floor that takes abuse without looking beat up, flake and chip epoxy floors are worth a hard look. This is a broadcast system: a base coat of resin gets laid down, vinyl flake chips get cast into it by hand until the surface is fully loaded, and once it cures, the whole thing gets scraped and sealed under clear coats. The result is a hard-wearing, speckled floor with real texture underfoot.
That texture matters. A smooth epoxy coat can read slick, especially when dusty or wet. Flake adds grip because the chips break up the surface, which is why flake floors are often chosen for areas where people walk fast or roll carts. It is not magic - any floor can be slippery when contaminated - but a flake surface generally feels more sure-footed than a gloss coat.
The other reason people pick flake: it hides dirt. The speckled blend breaks up the visual field, so dust, scuffs, and small debris do not announce themselves the way they do on a solid color. You still sweep and mop, but the floor looks decent between cleanings.
We install flake and chip epoxy floors in a range of commercial settings around Madison Heights:
If you want to understand how the system works in more detail - base coats, broadcast rates, seal coats - see the full breakdown on our flake epoxy guide.
The flake blend is what defines the look, and we do not ask you to pick one off a phone screen. Screen colors lie. The same blend can read gray on one monitor and blue on another, and flake blends shift again under your actual lighting once they are sealed.
So the blend choice is made from physical samples, in your space, under your lights. You can hold chips against your walls and trim, compare two or three blends side by side, and see how the flakes read at actual size. Flake sizes vary too - finer blends read more uniform, larger chips read more textured and busy. We will walk you through it, but the decision is yours, made with samples in hand.
We do not quote firm prices on a webpage, because two floors of the same square footage can come out very different. The main cost drivers:
As a broad framing only: flake systems sit above a single-color solid epoxy because of the extra material and labor in the broadcast, and below high-end resinous systems. You will get a specific, written number after we look at your slab.
Installed floors come with a written warranty on workmanship. It is in writing because we stand behind the install - no fine-print games.
For more on our local work, see the Madison Heights service page.
Ready to look at samples and get real numbers for your space? Use the quote form on our website. Tell us the square footage, what the space is used for, and roughly when you need it done. We will schedule a site visit and put together a written estimate - no pressure, no obligation.