Flake and Chip Epoxy Floors in Livonia, MI

Flake and chip epoxy floors in Livonia MI are a practical choice for commercial spaces that take real wear: shop floors, showrooms, restrooms, locker rooms, break rooms, and light industrial areas. The system is a broadcast floor. We roll down a resin base, cast vinyl flakes into it by hand until the surface is fully covered, let it cure, then scrape and seal with one or more clear topcoats. The result is a hard-wearing, speckled floor with a subtle texture that grips better than a smooth-coated surface.

This page covers how the system works, where it fits, and what drives cost. For the broader service area, see our Livonia, MI flooring page. For a deeper look at the material itself, read the flake epoxy guide.

How a flake floor is built

A flake system is layered, not poured all at once:

  1. Surface prep. The concrete is ground to open the surface and remove old coatings, cure, or contamination. Prep quality decides whether the floor stays down.
  2. Base coat. A tinted epoxy or polyaspartic resin is rolled out.
  3. Flake broadcast. Vinyl flakes are thrown into the wet resin at full coverage — enough flake that no base coat shows through. Excess flake is swept off once cured.
  4. Seal coats. Clear topcoats lock the flake in and set the final sheen, from matte to gloss.

The blend is your call. We bring physical samples to the site and you pick from those, not from a screen. Screen colors rarely match the real flake under shop lighting, so we don't quote from them.

Why flake reads as less slippery

Smooth epoxy coats can feel slick when wet or dusty. Flake changes that. The broadcast layer puts thousands of tiny flake edges into the surface, and the texture carries through the seal coats. The result is a floor with more grip underfoot — which is why flake and chip epoxy floors are common in restrooms, kitchens, entryways, and anywhere feet or forklifts meet moisture.

Flake also hides dirt, dust, and minor scuffs. The speckled pattern breaks up the surface visually, so the floor looks clean longer between sweepings. In busy Livonia facilities, that's a real maintenance saving, not a cosmetic one.

Where it fits in commercial spaces

Cost drivers, not fixed prices

We don't post firm prices because concrete doesn't allow it. What moves the number on a flake and chip epoxy floor:

We quote from the actual slab, on site, with a written breakdown of what's included. Installed floors carry a written warranty on workmanship, and we honor it — the terms are in the contract, not fine print.

Livonia specifics

Michigan freeze-thaw cycles and road salt tracked in through loading doors are hard on bare concrete and on thin coatings. A properly prepped flake system with adequate seal coats handles both. If your slab has heaving or active cracks, we'll tell you before we quote, because no coating fixes a slab problem.

Get a quote

If you're planning flake and chip epoxy floors for a commercial space in Livonia, MI, start with the quote form on our website. Send your square footage, location, and a few photos of the slab if you have them. We'll schedule a site visit and give you a written, itemized quote — no pressure, no obligation.