Flake and Chip Epoxy Floors in Clawson, MI

If you're weighing flake and chip epoxy floors in Clawson MI for a shop, warehouse, office, or service bay, the short version is this: it's a broadcast system, not a paint job. Vinyl flakes get cast by hand into a wet resin base coat, then the whole thing gets sealed under one or more clear coats. The result is a hard-wearing, speckled floor with real texture underfoot — one of the most practical commercial flooring options for busy spaces in Clawson, MI.

How the broadcast system works

The system is built in layers:

  1. Prep. The existing concrete is ground or shot-blasted to open the surface so the resin can bond mechanically. This step matters more than anything else in the process.
  2. Base coat. A tinted epoxy or polyaspartic resin goes down wet.
  3. Broadcast. Vinyl flakes are thrown into the resin until it's saturated — full broadcast. The flakes sit at every angle, which is what gives the floor its density.
  4. Scrape and seal. Once cured, the surface is scraped flat, the loose flakes are removed, and clear seal coats lock everything in.

Done properly, the floor reads as one continuous, sealed surface. No grout lines, no seams, no places for liquids to sit.

Why flake suits commercial floors

Two reasons flake and chip epoxy floors earn their spot in commercial settings:

Add in chemical resistance, easy damp-mopping, and a surface that tolerates forklifts and rolling loads, and the maintenance math usually works out well compared to sealed raw concrete or tile.

Choosing your blend — in person, not on a screen

Flake blends come in hundreds of colour combinations: greys, beiges, blacks, multi-colour mixes, and everything between. You pick your blend from physical samples, not from a screen. Photos and colour swatches on a monitor exaggerate contrast and saturation, and the same blend can read completely different under showroom lighting versus your shop's fluorescents. We bring samples, lay them against your existing walls and fixtures, and look at them in the actual space before anything gets ordered.

Cost drivers, not fixed prices

We don't quote firm prices sight unseen, because the range on these floors is wide. What moves the number:

For most commercial jobs, expect the total to land somewhere between a basic solid-colour epoxy floor and a high-end polished or resinous system. A site visit gets you a real number.

Why work with us

Every installed floor is backed by a written warranty on workmanship. It's in writing because we intend to honour it — if something goes wrong with our installation, that's on us to fix. You can read more about the systems themselves in our flake epoxy guide.

Get a quote

If you're ready to spec flake and chip epoxy floors for your Clawson property, submit the quote form on our website. Tell us the square footage, the space's current condition, and how the floor is used, and we'll come out, look at the slab, walk you through blend samples in person, and give you a straight quote. No pressure, no hard sell — just a clear picture of what your floor needs and what it will cost.