Flake and Chip Epoxy Floors in Bloomfield Hills, MI

Flake and chip epoxy floors in Bloomfield Hills MI are a practical choice for commercial spaces that take daily abuse — auto showrooms, retail back-of-house, workshops, light industrial bays, and busy garage areas. The system is straightforward: a base coat of resin, vinyl flakes broadcast by hand into the wet surface until it's saturated, then a scrape and seal with clear topcoats. The result is a hard-wearing, slip-resistant floor with a speckled finish that hides dirt, dust, and scuffs far better than a solid color coat.

If you want the full technical breakdown of how the system works, see our guide to flake epoxy. This page covers how we install it for commercial properties in Bloomfield Hills and the surrounding Oakland County area.

How the Broadcast System Works

A flake system is built in layers:

  1. Surface prep. The concrete is ground to open the surface and remove old coatings or sealers. This step matters more than anything else in the process — flakes can't bond to a sealed or contaminated slab.
  2. Base coat. A pigmented epoxy or polyaspartic base is applied at the chosen color.
  3. Broadcast. Vinyl flakes are thrown into the wet base until the surface can't accept any more. This full saturation is what gives the floor its density and texture.
  4. Scrape and sand. Once cured, the excess flake is scraped back so the surface is flush and even.
  5. Seal coats. One or more clear topcoats lock the flakes in, set the sheen, and determine the final texture and chemical resistance.

The sealed surface resists tire marks, oil, forklift traffic, and most common chemicals used in commercial settings.

Why the Texture Matters

The flakes sit in the resin and the seal coats, leaving a slightly rough profile. That texture is the whole point: it reads as noticeably less slippery than a smooth solid-color coat, especially when wet. For entryways, garages, and any space where customers or staff walk through with wet boots, that's a real safety difference, not just a cosmetic one.

The speckled blend also hides dirt between cleanings. Facilities that can't mop every day stay looking presentable longer, which is one of the main reasons property managers pick flake over a plain coat.

Choosing a Flake Blend

Blend choice is made from physical samples, not from a screen. Photos of flake floors are notoriously unreliable — camera settings and screen calibration change how a blend reads, and two blends that look similar online can look very different on a floor. We bring sample boards so you can see the actual flake sizes, density, and color mix under your own lighting, then confirm the blend before anything is mixed.

Blends range from neutral grays and tans to darker charcoal mixes, and coverage density can be adjusted — full broadcast for maximum durability or a partial broadcast for a lighter look with more base color showing through.

What Drives Cost

We don't quote firm prices without seeing the slab, but the main cost drivers are consistent:

As a rough range only: most commercial flake projects land in a per-square-foot cost well below tile replacement or full slab replacement, which is part of why flake and chip epoxy floors are a common retrofit choice.

Our Workmanship, In Writing

Every installed floor is covered by a written warranty on workmanship. The terms are spelled out in the contract, so you know exactly what's covered before the project starts — not after something goes wrong.

Get a Quote

If you manage or own commercial property in Bloomfield Hills and want a floor that holds up and stays looking clean, submit the quote form on our website. Tell us the square footage, how the space is used, and your timeline, and we'll come out, look at the slab, and put a written estimate together.