Flake and Chip Epoxy Floors in Ann Arbor, MI

Flake and chip epoxy floors in Ann Arbor MI are a practical choice for commercial properties that need a floor to hold up under real traffic - shops, break rooms, restrooms, showrooms, garage bays, and back-of-house areas. The system is straightforward: a base coat of resin, vinyl flake broadcast into it while it's wet, then sealed with clear coats once cured. The result is a hard-wearing, speckled floor with built-in texture that hides dirt far better than a smooth, solid-color coat.

How the Flake System Works

Flake flooring isn't a paint job. It's a build-up of layers:

  1. Prep - the concrete is ground to open the surface, so the base coat bonds mechanically rather than sitting on top.
  2. Base coat - tinted resin rolled out and flaked heavily while it stays wet.
  3. Broadcast - vinyl chips are cast in until rejection, then the excess is swept off once cured.
  4. Seal coats - clear coats lock the flake in and set the final sheen and texture.

That seal coat matters more than people expect. It determines whether the floor reads as smooth or grippy, and it's what stands between the flake and forklifts, floor scrubbers, and spilled fluids.

Why Flake Reads as Less Slippery

This is the question we get most from Ann Arbor facility managers, especially for restrooms and entryways where water and slush come through. The flake adds texture to the surface - a physical profile underfoot - so it reads as less slippery than a smooth resin coat in the same conditions. Nothing is slip-proof when it's wet, but a textured flake floor gives better foot traction than gloss-on-gloss, and it can be tuned by how much sealer is applied and whether an aggregate is added to the top coat.

Hides Dirt, Hides Imperfections

The speckled, multi-tone look is a working advantage, not just aesthetics. Dirt, scuffs, sawdust, and small debris visually disappear between cleanings. On a smooth single-color floor, every crumb and tire mark shows. For busy commercial spaces in Ann Arbor MI where cleaning schedules are realistic rather than ideal, that difference is noticed within the first week.

The flake also masks minor variations in the concrete beneath. Old slabs rarely come out perfectly uniform, and a solid-color coat telegraphs every patch and trowel mark. Flake breaks that up.

Choosing a Blend

Blend choice is made from physical samples, not from a screen. Flake blends are named by their color mix - grays and charcoals are common in commercial settings, but the combinations are wide open, and the same blend can read differently depending on lighting and sheen. We bring or arrange samples so you can see the actual chips and color balance in your space, under your lighting, next to your walls and fixtures. Photos online flatten the effect; don't pick a floor you'll live with for a decade from a thumbnail.

What Drives Cost

We don't quote firm prices sight-unseen, because the same square footage can vary meaningfully. The main drivers:

As a general frame, commercial flake systems typically run in the mid single digits to low teens per square foot installed, depending on the factors above. We'll give you an actual number after seeing the slab.

For more on the system itself, see our overview of flake and chip epoxy floors, or browse our other work in Ann Arbor.

Warranty

Floors we install are covered by a written warranty on workmanship. It's in writing because we stand behind the install, and the terms are spelled out plainly before work begins.


Get a Flake Floor Quote

Tell us about your space through the quote form on this site - square footage, current floor condition, and what the space is used for. We'll review it and follow up with next steps and scheduling for an on-site look. No phone tag required.