Epoxy Floor Repair and Recoat in River Rouge, MI

If your existing epoxy floor is wearing out, an epoxy floor repair and recoat in River Rouge MI can often bring it back without the cost of a full tear-out and re-pour of coating. Shops, warehouses, and light industrial buildings around River Rouge put real demands on their floors — forklifts, hot tyres, salt tracked in off Jefferson, chemicals, and constant foot traffic. Coatings that were installed thin, or over poorly prepared concrete, eventually show it.

This page explains what we repair, when a recoat makes sense, and — just as importantly — when it does not.

What We Repair and Recoat

We work on existing resin floors that have:

Repair might mean spot-fixing damaged areas, re-profiling the surface, or applying a full recoat over a sound, properly prepared floor. Often it is a combination: repair the bad sections first, then recoat the whole area so the finish is uniform.

When a Recoat Is the Wrong Answer

Here is the part some contractors skip: sometimes recoating over a failing floor just hides the problem for a year or two, and then you pay twice.

If the existing coating is delaminating across large areas, if the concrete underneath is contaminated with oils or curing compounds, or if the original floor was applied over a weak or unsound slab, bonding a new coat on top will not last. In those cases the honest answer is to take the floor back to concrete — mechanically removing the old coating, dealing with the slab, and starting the coating system properly.

We tell you this before the work starts, not midway through the job. Every epoxy floor repair and recoat we quote in River Rouge MI starts with an assessment of what is actually on your slab and how well it is bonded. If a full strip-back is the right call, you hear it upfront, with the reasoning, so you can budget accordingly.

How Recoating Works

When the existing floor is a good candidate, the process is straightforward:

  1. Clean and assess — identify all failed areas, test adhesion of the existing coating
  2. Repair — fill cracks, patch damaged sections, feather transitions
  3. Mechanical prep — grind or abrade the surface so the new coat bonds properly
  4. Recoat — apply the new coating system, with slip-resistant additive or line marking where needed

Surface prep is the difference between a recoat that lasts and one that lifts in a season. We do not skip it, and we do not cut it short.

What Affects Cost

We do not publish firm prices because no two floors are the same, but the main drivers are:

You get a written quote that breaks these out, so you know what you are paying for.

Why Local Matters

River Rouge floors deal with industrial traffic, river humidity, and salt in winter. We work throughout Wayne County and know the building stock here — see our full service area for River Rouge, MI and nearby communities. For a deeper look at repair methods, crack filling, and delamination causes, see our main guide on epoxy floor repair.

Every floor we install is backed by a written warranty on workmanship, and we honour it.

Get a Quote

If your floor is peeling, worn, or lifting at the tyres, send us the details through the quote form on this website. Include the approximate square footage, what the floor is used for, and photos of the worst areas if you can. We will assess it and give you a straight answer — recoat, repair, or strip and start over — before any work is quoted.