Epoxy Floor Repair and Recoat in Mount Clemens, MI

If your epoxy floor is peeling, worn through, or lifting where tyres turn, epoxy floor repair and recoat in Mount Clemens MI can often bring it back without the cost of a full tear-out and replacement. But not every damaged floor should be recoated — and we will tell you which kind you have before any work starts, not halfway through the job.

We work with commercial and industrial properties throughout Mount Clemens and Macomb County: warehouses, service bays, light manufacturing, and retail floors that have simply taken years of traffic.

When a Recoat Is the Right Answer

An existing resin floor is a good candidate for epoxy floor repair and recoat when:

In these cases, we repair the damaged sections, re-profile the surface, and apply fresh coats. You get a floor that looks and performs close to new for a fraction of a replacement budget.

When Recoating Is the Wrong Answer

Sometimes a recoat just seals a problem in. If the original coating failed because of poor surface prep, a moisture-vapour issue in the slab, or incompatible chemistry between coats, a new layer will peel off on the same schedule as the last one.

Signs that the floor needs taking back to concrete instead:

We say this before the work, not during. A site assessment tells us what is actually happening under the coating, and we give you a straight recommendation — repair and recoat, or strip and start over. For a full look at how we approach damaged floors generally, see our epoxy repair overview.

How the Work Is Done

A recoat is only as good as the prep underneath it. Our process:

  1. Assessment and testing – bond checks, moisture checks, and a map of all damaged areas
  2. Mechanical prep – diamond grinding or shot blasting to create a proper profile for adhesion
  3. Repairs – patching cracks, spalls, and lifted sections so the surface is level again
  4. Priming and recoating – compatible primer and topcoats applied to spec
  5. Optional finish – new flakes, anti-slip additive, or line marking where wanted

Downtime depends on floor size and how many repairs are needed. Many recoats are back in service within a few days, including cure time. We will give you a realistic schedule before quoting.

What Drives the Cost

We do not quote prices sight-unseen, because two floors of the same size can be very different jobs. The main cost drivers are:

A simple recoat over a sound floor sits at the low end of these jobs. Strip-and-replace sits at the high end. The assessment is what tells you which one you are paying for.

Warranty and Next Steps

Installed floors are covered by a written warranty on workmanship — in writing, on paper, because we stand behind the prep as much as the coating.

If you are in Mount Clemens MI or the surrounding area and your epoxy floor is wearing out, peeling, or hot-tyre lifting, submit the quote form on our website. Tell us roughly what you have — floor type, approximate size, and what is going wrong — and we will arrange an assessment and a straight answer on whether a recoat will hold up or not.