Basement and interior floor coating in Ypsilanti MI is a different job than coating a garage slab or a warehouse floor in the open air. Below-grade concrete sits against soil that holds moisture. That moisture moves through the slab as vapor, and if the coating system isn't chosen and installed with that in mind, it will fail — usually within the first year. This page covers how we approach commercial basement and interior floor coating in Ypsilanti, Michigan, and why the first step is always testing, not selling.
Ypsilanti has its share of older commercial buildings with basement and ground-level slabs that were never meant to be finished floor space. When you coat concrete that sits below grade, you're dealing with a slab that can push moisture upward continuously. A coating that would last ten years on an above-grade slab can bubble, peel, or delaminate on a below-grade one in a single season if moisture vapor drive wasn't accounted for.
That's not a product defect. It's a physics problem. Water vapor moves from wet to dry — from the soil, through the slab, toward the drier interior air. The coating sits in that path. If the system can't handle the vapor load, the vapor lifts it off the concrete.
We test moisture conditions in the slab before recommending any system. That may include calcium chloride testing or in-slab relative humidity probing, depending on the slab's age, history, and what the space will be used for. Some contractors skip this step and quote a price on the spot. Then the floor fails, and the property owner pays twice.
Skipping testing is how a basement floor fails in a season. Testing first costs a little more up front and a lot less over the life of the floor. If a slab shows high vapor drive, the honest answer might be a moisture-tolerant primer, a vapor-mitigation layer, or in some cases a recommendation to address drainage or grading before coating at all. We'd rather tell you that than sell you a floor that won't hold.
Once we know what the slab is doing, we specify from systems that suit interior service conditions:
Every system is matched to the slab's moisture behavior first and the appearance second. On below-grade work, that order isn't negotiable if you want the floor to last.
We don't publish fixed pricing because slab condition and moisture levels change the scope. The main drivers are square footage, surface preparation depth (old coatings or sealers add cost), moisture mitigation requirements, and the coating build you choose. As a general range, interior commercial coating work commonly lands between $4 and $12 per square foot, with heavy moisture mitigation pushing higher. You'll get a firm number after testing and a site walk.
We work throughout Ypsilanti, MI on commercial basements, lower-level retail, service bays, and interior utility floors. Every installed floor is backed by a written warranty on workmanship — in writing, not a verbal promise — because we stand behind how the floor was prepared and installed.
For a broader look at how we evaluate and coat below-grade slabs, see our guide to basement floor coating, or browse our other service areas.
If you're planning basement or interior floor coating for a commercial property in Ypsilanti, MI, start with the quote form on our website. Tell us about the space, the slab's age and history, and how the floor will be used. We'll schedule moisture testing and a site evaluation, then give you a system recommendation and pricing based on what the slab actually needs — not a guess over the phone.