Basement and interior floor coating in South Lyon MI is a different job than coating a garage slab or a warehouse apron. Below-grade concrete behaves differently. Groundwater and soil moisture push vapor up through the slab, and if a coating is applied without accounting for that, the floor can blister, peel, or delaminate within a season. We handle commercial basement and interior floor coating for property owners in South Lyon, Michigan, and the first thing we do on any below-grade slab is test it.
A basement slab sits against damp soil for its whole life. Concrete is porous, and moisture vapor migrates upward through it continuously. When an impermeable coating is installed over a slab pushing more vapor than the coating can tolerate, that vapor builds pressure under the film. The result is bubbling, adhesion loss, and failure that shows up fast — often in the first heating and cooling cycle after installation.
Interior slabs at grade can have moisture issues too, especially newer concrete that has not fully cured or slabs without an effective vapor barrier underneath. The point is the same either way: moisture behaviour matters as much as appearance on these floors.
Some contractors skip moisture testing and just roll a coating down. If the slab happens to be dry, the floor holds. If it does not, you are paying twice — once for the failed floor, once for the redo.
We test moisture vapor emission and, where warranted, internal relative humidity before recommending a system. The results determine what we install: a standard epoxy or polyaspartic build where the slab is manageable, or a moisture-tolerant primer and system designed for higher vapor drive where it is not. Testing is not an upsell. Skipping it is how a basement floor fails in a season.
If a reading comes back beyond what a coating can handle, we tell you that plainly and talk through remediation options rather than installing something we know will fail.
The right system depends on the slab, the moisture conditions, and how the space is used. For commercial interiors in South Lyon, that typically means one of the following:
Finish options include solid color, decorative flake, and slip-resistant additives where the floor will see foot traffic in wet conditions.
We do not quote firm prices without seeing the slab, but the main cost drivers are consistent: square footage, the amount of surface prep required (crack repair, leveling, grinding), moisture conditions and whether a specialty primer is needed, and the coating system selected. An interior floor in good condition with low vapor drive costs considerably less than a below-grade slab that needs remediation first. Any quote we provide is itemized so you can see what you are paying for.
Every floor we install is backed by a written warranty on workmanship. It is not fine print — it is a document that spells out what is covered and what is not, and we stand behind it. You will have it in hand before the job starts, not after something goes wrong.
We work with commercial property owners throughout South Lyon and the surrounding area. For a broader look at the city and our full service coverage, see South Lyon, MI. For more detail on systems, prep, and moisture considerations, see our basement floor coating guide.
If you are planning basement and interior floor coating for a commercial property in South Lyon, start with the quote form on our website. Tell us about the space, the slab, and how it is used, and we will schedule an on-site evaluation with moisture testing included. No pressure, no obligation — just a clear assessment of what your floor needs.