Basement and Interior Floor Coating in Romulus, MI

Basement and interior floor coating in Romulus MI is a different job than coating a garage or a warehouse apron. Most commercial basements and ground-level interior slabs in this area sit on or below the water table for at least part of the year. That means moisture moves through the concrete from underneath, and whatever you put on top has to be specified with that in mind. We install basement and interior floor coating systems for commercial properties across Romulus, Michigan, and the first step on every below-grade slab is the same: figure out what the concrete is doing before we seal it.

Why Below-Grade Concrete Behaves Differently

Concrete is porous. On a slab that sits below grade, water vapor pushes up through that concrete continuously, driven by moisture in the surrounding soil. A coating that would last ten years on an above-grade slab can fail in one season on a basement floor if that vapor pressure was never accounted for. The typical failure looks the same every time: peeling, blistering, or a cloudy white haze under the film where moisture has collected.

This is not a mystery. It is predictable, and it is testable.

Moisture Testing First — Because Skipping It Is How Floors Fail

We test moisture vapor emission and, where warranted, internal relative humidity before recommending a system on any below-grade slab. Some contractors skip this or treat it as an upsell. It is not. Testing tells us which coating chemistry and which preparation method will actually hold on your floor. Skipping it is how a basement floor fails in a season — and the property owner pays for it twice: once for the coating that failed, and again to strip it and start over.

If testing shows high vapor drive, we have options: moisture-tolerant primers, epoxy moisture barriers installed before the finish coat, or in some cases a recommendation to address drainage or grading before coating at all. We would rather tell you that upfront than sell you a floor that peels next spring.

Interior Coating Systems We Install

For interior and basement slabs that pass testing (or after a moisture barrier is in place), we install:

Preparation is mechanical grinding or shot blasting on every job, never just an acid wash. Coating adhesion lives or dies on surface profile.

Cost Drivers, Not Guesswork

We do not quote basement floors blind. Cost depends on slab size and condition, crack and joint repair needed, moisture test results, and the coating system specified. A clean slab with low vapor emission costs far less than one that needs a moisture barrier and two days of repairs. After testing, you get a written scope with the system, preparation, and workmanship detailed — so you know what you are paying for and why.

Serving Romulus Commercial Properties

Romulus sits next to Detroit Metro Airport with heavy industrial and logistics activity, and a lot of that real estate has usable basement and lower-level space with raw concrete floors. We work with facility managers, building owners, and general contractors throughout the area. For the broader service area, see Romulus, MI, and for system details across all floor types, see our basement floor coating guide.

Every installed floor is backed by a written warranty on workmanship. If something we installed fails because of how we installed it, that warranty means something — it is in writing, and we honor it.

Get a Quote

If you have a basement or interior concrete floor in Romulus that needs coating, submit the quote form on this website. Include the approximate square footage, what the space is used for, and whether the slab is below grade. We will schedule a site visit, test the slab, and give you a written scope with real numbers.