Illustrative composite based on typical scenarios. Names, companies, and figures are representative examples, not a specific verified customer.
This is an illustrative walkthrough of an epoxy floor repair and recoat job of the kind we see regularly around metro detroit — a two-car garage or small shop floor, coated years ago, now showing its age. No client names, no invented numbers. Just the shape of the problem, the approach, and what a floor owner should realistically expect.
The floor was originally coated roughly eight to ten years earlier. It was never a bad install, but time and use caught up with it: hot-tire pickup near the door openings, small chips where tools had been dropped, dull traffic lanes down the center of the space, and a handful of spots where oil had sat long enough to soften the coating. The floor was still bonded in most areas. The owner wanted it to look clean again without paying for a full tear-out.
That description fits a large share of the recoat inquiries we get. The key question is never "can it be recoated?" It's "how much of it can be recoated?"
Here's the part that matters: sometimes a recoat is the wrong answer. If the original coating was applied over moisture or a poorly prepped slab, if it's delaminating in broad sheets, or if the surface film is too thin and worn to bond to, the right move is grinding back to bare concrete and starting over. That gets said before the work is quoted, not discovered midway through. A recoat over a failing floor just moves the failure date forward and costs the owner twice.
On a typical floor like this one, most of the surface passed the bond test — a simple cross-hatch and pull check on cleaned areas. A minority of spots failed and were marked for full repair. That split determines the scope, and it's why a proper evaluation comes before any estimate.
The job broke into three stages:
Timeline: most garages and small shops of this type are back in service within a few days, with the bulk of that being cure time rather than labor. Foot traffic typically returns before vehicle traffic, and the contractor's guidance on cure windows should be followed exactly — that's where recoats get damaged.
Cost: driven by how much area needs true repair versus simple recoat, the number of coats, flake or solid finish, and square footage. Ranges vary widely enough that any firm price stated in a general article would be misleading. Get a quote based on an actual inspection. Our quote form on the website is the starting point for that.
Durability: a properly prepped recoat over sound coating can add years of service life. A recoat over a failing floor buys almost nothing. Installation work is covered by our written warranty on workmanship — the terms are spelled out on the job paperwork, not invented here.
For the full picture on failure modes, repair methods, and when full removal makes more sense, see our epoxy repair pillar: Epoxy Floor Repair.
If your floor matches the description above — worn, chipped, dull in traffic lanes, but mostly still bonded — submit the quote form on our website. Include approximate square footage, the floor's age, and photos of the worst areas. You'll get an honest answer on whether a recoat is the right call or whether the floor needs to come back to concrete first.