Why the cheapest quote is usually the thinnest system

If you manage a facility and you're collecting bids for epoxy flooring, you've probably noticed the spread. Three quotes for the same square footage can land miles apart, and the temptation is to treat them as interchangeable and take the lowest. Before you do, it's worth understanding why the cheapest quote is usually the thinnest system — not because the contractor is dishonest, but because the easiest place to cut cost on a concrete floor coating project is the parts you can't see once the job is done.

Where the money actually goes

A floor coating system has three cost drivers: surface preparation, material thickness and quality, and labour time. A low quote almost always means one or more of those got reduced.

Surface preparation. Proper prep means grinding or shot-blasting the concrete to open the surface and remove contaminants, then repairing cracks and joints. It's slow, dusty, expensive work — and it's invisible in the finished floor. Skip it or thin it out, and the coating can peel, bubble, or delaminate within a year or two, especially under forklift traffic or in areas that get washed down.

Film thickness. A quote that doesn't state mils (coating thickness) per coat is a quote you can't compare. A thin single-coat system uses a fraction of the material of a proper primer-plus-body-coat-plus-topcoat build. Cheaper epoxy flooring products also tend to have lower solids content, which means less actual film left on the floor after curing.

Number and type of coats. Primer matters. It seals the porous concrete and bonds the body coat. A bid with "one coat of epoxy" isn't the same product as a bid with primer, two body coats, and a wear topcoat — it just covers the same square metres.

What "thin" costs you over time

The up-front saving on a stripped-down system is real, but so is the follow-on cost. A floor that fails early means downtime for recoating, and recoating a failed floor usually costs more than doing it right the first time, because the failed coating has to be removed first. There's also disruption you can't put a clean number on: blocked aisles, rescheduled production, staff working around cure zones.

A useful rule: ask each bidder to specify, in writing, the prep method, each coat, the product and its solids content by weight, and the target dry-film thickness per coat. Quotes that answer those four questions cleanly are comparable. Quotes that don't are quoting a different floor.

Reasonable ranges, not prices

Every project is different, so it makes no sense to quote figures here. But as cost drivers to discuss with any bidder:

Questions that separate the bids

When you sit down with the quotes, ask each contractor:

  1. What prep method, and how will you verify the profile?
  2. How are you handling cracks, joints, and moisture testing?
  3. What is the coat-by-coat build, with mils per coat?
  4. What is the cure and return-to-service schedule?
  5. What does the warranty cover, and is it in writing?

That last one matters more than most people realise. A contractor who stands behind their work with a written warranty on installed floors is telling you they expect the system to last. A verbal "it'll be fine" is not the same thing. Our written warranty on workmanship is honoured, not just offered — but the specific terms belong in your quote conversation, not in a generic page like this one.

The honest comparison

The cheapest quote is usually the thinnest system because thickness and prep are the only levers a contractor can pull without you noticing on handover day. You notice eighteen months later. Two bids within a reasonable range of each other, both fully specified, are almost always a better outcome than one bid far below the rest — the low bid isn't a discount, it's a different floor.

Get a specified quote

If you'd like a quote that spells out prep, coats, thickness, products, and schedule in plain language — backed by our written warranty on workmanship — use the quote form on our website. Tell us the square footage, the current slab condition, and how the floor is used, and we'll come back with a system you can compare line by line against any other bid you're holding.