Moisture vapour testing explained

If you manage a warehouse, workshop, or commercial space and you're budgeting for a new floor coating, moisture vapour testing is the step most likely to save you from a failed floor. This page is moisture vapour testing explained in practical terms: what it is, why it matters, how it's done, and what it costs to get right.

What is moisture vapour testing?

Concrete looks solid, but a slab is full of capillaries - tiny channels that allow water vapour to move from the ground beneath up through the surface. Even a slab that feels bone-dry to the touch can be releasing significant moisture vapour. When that vapour meets an impermeable film like epoxy flooring, it builds pressure underneath and can cause blistering, delamination, clouding, or adhesive failure.

Moisture vapour testing measures how much vapour is moving through the slab before a coating is installed. The result tells the installer whether the concrete is dry enough for the chosen system, and if not, what remediation is needed.

Why skipping it is expensive

A concrete floor coating is only as good as its bond to the slab. If moisture vapour isn't measured and managed:

Most reputable coating manufacturers condition their warranties on documented moisture testing. Skip the test and you may void the product warranty before the floor is even poured onto the slab.

The common test methods

Plastic sheet test (ASTM D4263)

A square of polyethylene sheet is taped to the slab for around 16-24 hours. Condensation underneath indicates moisture. It's cheap and quick, but it's only a rough pass/fail indicator - it doesn't give a quantifiable result suitable for specifying a coating system.

Calcium chloride test (ASTM F1869)

A small dish of calcium chloride is sealed under a dome on the slab and weighed before and after a set period (typically 60-72 hours). The weight gain gives a moisture vapour emission rate, usually expressed in pounds per 1,000 square feet per 24 hours. Many epoxy flooring manufacturers specify a maximum emission rate for their products.

In-slab relative humidity probe (ASTM F2170)

A hole is drilled into the slab and a sensor sleeve is installed at roughly 40% of the slab depth. After an equilibration period - usually 24-72 hours depending on the procedure - the internal relative humidity is read. This method is generally considered the most reliable because it measures moisture conditions inside the slab, not just at the surface.

A thorough pre-coating assessment will often combine pH testing (excess alkalinity can also attack coatings) with one or both of the quantified moisture methods.

What the results mean

Results fall into broad bands:

The key point: high readings don't mean you can't coat the floor. They mean the system specification changes, and the cost changes with it.

What drives the cost

Costs vary by site, slab age, and how many test points are required. The main drivers:

Rather than quoting blind, we treat testing as a fixed scope item so you know the number before committing to the coating work.

Practical tips for facilities managers

How we handle it

Moisture testing is a standard part of our pre-installation process on coated floors. If readings are elevated, we'll show you the numbers and recommend a system - such as a moisture-tolerant primer or vapour barrier layer - that suits the conditions. Workmanship on installed floors is covered by a written warranty, so there's a documented basis for the system we install.

If you're planning an epoxy flooring project and want testing included from the start, send through your site details and slab information via the quote form on our website, and we'll come back with a scoped proposal.