Illustrative composite based on typical scenarios. Names, companies, and figures are representative examples, not a specific verified customer.
This page walks through a typical epoxy floor repair and recoat job, drawn from patterns we see repeatedly across metro detroit. It is a composite, not a single project. The point is to show what the process looks like, what can go wrong, and how an owner should expect a contractor to handle it.
A two- to three-car residential garage or small workshop floor, coated years earlier, showing its age. Common symptoms:
None of these alone means the floor is finished. The question is whether the existing coating is still bonded well enough to recoat over.
This is the decision that matters, and we make it before any work is quoted as a recoat. A recoat only works over a sound, clean, well-bonded existing coating. If the old coating is lifting, delaminating in sheets, or was never properly bonded to the slab in the first place, a recoat will fail exactly where the old coat failed.
So the assessment is simple: we test adhesion, check for moisture coming up through the slab, and map where the coating is bonded versus where it is not. If the majority of the floor is solid, repair and recoat makes sense. If large sections are loose, the honest answer is that the floor needs to be taken back to concrete and redone — and we say that before the work starts, not midway through.
You can read more about how we evaluate a failing floor in our epoxy repair guide.
For a floor that passes the recoat test, the sequence looks like this:
Most single- or two-day jobs once the surface work is done, with a cure period before vehicle traffic. Exact timing depends on the product and the season — a cold metro detroit garage in February is a different conversation than one in July.
We do not publish firm prices because two floors that look identical can be very different jobs. The main cost drivers:
A straight answer on recoat-versus-strip before work begins. A written warranty on workmanship covering the installed floor. A surface prepped properly, because prep is where recoats succeed or fail. And a floor that looks renewed, not patched over.
If your floor is dull, peeling, or cracking, the first step is an assessment, not a quote. Fill out the quote form on this site and we will take a look and tell you honestly whether a recoat will hold or whether the floor needs to be stripped.