Illustrative composite based on typical scenarios. Names, companies, and figures are representative examples, not a specific verified customer.
This is a generic walkthrough of how concrete grinding and surface preparation actually unfolds on a project, using a scenario typical of work in metro detroit: an older commercial space with a tired, previously coated slab. No client names, no invented numbers — just the shape of the job so you know what to expect when you request a quote.
The floor in question had an existing paint-style coating that was flaking in traffic lanes, with patchy adhesion everywhere else. The owner wanted a new epoxy coating because the floor looked bad and was hard to clean. The obvious mistake here would have been to quote a coating directly over the old finish. That coating would have failed within a couple of years, because new coatings bond to the slab itself — not to someone else's failed coating.
Most coating failures are preparation failures, not product failures. The product on this floor was probably fine when it went down. What killed it was what sat between the coating and the concrete: contaminants, a weak surface layer, and a finish profile the coating could never grip.
The correct sequence is boring and that's the point:
On this kind of job, grinding is typically the largest single line item, and it's the one a low quote tends to quietly skip or minimize. A quote that skips grinding is not cheaper, it is shorter-lived. You're comparing two different products: a floor that lasts, and a floor that looks good until the first winter.
Firm prices belong in a quote, not on a page, but the drivers are predictable:
A properly prepped and coated floor means the slab profile is consistent, repairs are flush, and the coating bonds to concrete, not to hope. Expect the contractor to talk about grinding before they talk about colors. Expect a written warranty on workmanship on the installed floor — and read what it actually covers. If a quote prices the coating in an afternoon without meaningful prep time, that's not a deal, it's a schedule for a redo.
For a fuller picture of how we approach prep, see our concrete preparation guide: Concrete Prep.
If your floor has a failing coating, the honest answer starts with grinding, not a color chart. Fill out the quote form on our website with your approximate square footage, the current floor condition, and a few photos. You'll get a scope that shows prep work as its own line item — so you can compare quotes on like-for-like floors, not like-for-like promises.